Supplies You Will Need

• Two-Part 3D Soap Molds
• Soap Rope
  • 18" in length (or longer)
  • Approx. 1/4" in Diameter
  • Heat sealed or knotted at the ends.
• CP Soap Making Supplies
• Fragrance or Essential Oil
• Optional: Colorant

Measure Your Rope

Measure the length of rope necessary to embed the rope half-way into the bar, to the top of the funnel.

Prepare Your Rope

Turn the rope around and tuck the remaining rope under the rubber band.

Pour Your Soap

After mixing, pour the soap at a light trace, slowly and steadily into the mold.

Overfill the soap molds cavity by pouring an excess into the funnel. This will act as a reserve and eliminate any large air pockets from forming at the top of the bar.

Lightly tap the soap mold onto the table to release any trapped air, and if necessary, refill the funnel reserve.

Embed Your Rope

Using a stick or wire, push the heat sealed end of the rope into the mold cavity, through the funnel. Embedding the rope into the center of the bar.

Center the rope in the funnel (left to right), and tap the soap molds onto the table to resettle the soap.

Finishing Your Soap on a Rope

Unmold the soap when it is ready, and trim away any excess material or "flashing" from the bar, and around the rope.

This completes the Cold Process Soap on a Rope Tutorial. Thank you for your interest!

3D Mold, CP Soap on a Rope Help, MP Soap on a Rope Help,
3D Standard Soap Help, Mold Home Page

3D Molds, Animals, Basic Shapes, Celestial, Celtic, Chocolate, Embeddable, Exclusives, Feng Shui, Flexible, Floral, From The Sea, Fruits, Fun Stuff, Garage Sale, In Flight, Mini Molds, Rainforest,  Southwestern,
  Special Occasions, Symbols, Victorian, Wood Molds, Word Bars